I-2022 Ozone

Dissolved Ozone SAM Kit

Measures ozone 0 to 0.75 ppm and has a digital LED readout

Ozone Information

$563.00
1 In Stock

The I-2022 Dissolved Ozone Meter is designed for accurately and quickly measuring ozone in water levels from 0 to 0.75 ppm. This device uses the Indigo Method for testing.  This method is based on the decolorization of dye by ozone, where the loss of color is directly proportional to the ozone concentration. The test reagent is formulated with malonic acid to prevent interference from chlorine. Results are displayed on the meter in ppm (mg/L) of ozone present.

This device has LED display for precise and accurate readout and is easy to use.  Once the I-2022 has been purchased the cost per test is only $1.02.

What's Included:

     -SAM Photometer (I-2022)

     -K-7433 Ozone Vacu-vials

     -A blank/zero ampoule

     -25 mL sample cup

     -4 AAA batteries for operation

     -Screwdriver for installing/replacing batteries

     -Instruction manual

     -Carrying case to hold device & accessories

 

How to Use:

Before beginning the test, the I-2022 must be set to zero. Press the power key to turn on the device. The display will show "O3". Insert the ZERO ampule supplied with the Vacu-vials kit flat end first into the sample cell compartment. Place the light shield over the ZERO ampoule and press the zero/test key. The "O3" symbol will flash for approximately 8 seconds, then the display will show "0.0.0". Follow the test procedure in the Chlorine Vacu-vials kit also shown below.

1. Fill the sample cup to the 25 mL mark with the sample to be tested being careful to minimize turbulence.
2. Immediately place the Vacu-vial ampoule tip-first into the sample cup. Snap the tip and the ampoule will automatically fill.
3. To mix the ampoule, tilt it from side to side, allowing the bubble to travel from end to end.
4. Dry the ampoule then insert it into the photometer, flat end first, and obtain a reading in ppm.

 

All CHEMetrics Kits for Ozone:

Vacu-Vials Instrumental
Product Number Method   Range
k7433 Indigo   0-0.75 ppm
I2022 Indigo   0-0.75 ppm
K7423 DPD   0-5.00 ppm
I2019 DPD   0-5.00 ppm
Chemets Kit Visual
Product Number Method MDL Range
K7404 DPD 0.025ppm 0-0.6 & 0.6-3ppm

 

Downloads:

I-2022 Instructions

Safety Data Sheet

K-7433 Instructions

Ozone Information

 

More Information
Manufacturer CHEMetrics
Quickbooks Stock Level 1.000000
Call For Price No
Gas Ozone (O3)
Listing Description

Digital ozone test kit to measure ozone in water at low levels.  Great for accurate low-level ozone detection.

4-20 mA Output No
Voltage Output None
Power Requirements 4 AAA Batteries
Datalogging No
Warranty 1 Year
Method Indigo
Range 0 - 0.75 ppm
Write Your Own Review
You're reviewing:I-2022 Ozone
We found other products you might like!
Loading...